Pages

Tuesday, May 24, 2016

How are diamond tips added to circular saw blades?

Who knew?
But its a totally cool process

Check out this process on http://www.nortonabrasives.com/en-us/resources/expertise/Understanding-Diamond-Blades

http://www.nortonabrasives.com/en-us/resources/expertise/Understanding-Diamond-Blades

Wednesday, May 4, 2016

Tuesday, May 3, 2016

What have you done with your circular saw lately?

Here is what I built last week out of scrap lumber.
www.mycircularsawblades.com
Now that it is Spring Time, I am ready to start working on some projects.  Here is my new favorite website for DIY.  This website is so Awesome  YELLA WOOD there are tons of cool plans for great projects.

Many of these projects require a circular saw or a table saw.

http://www.yellawood.com/?gclid=Cj0KEQjwmKG5BRDv4YaE5t6oqf0BEiQAwqDNfNdeK3i5Dr_7k3dgoo6NIyb0gNyufSpRio4CvzoiMFIaAskC8P8HAQ


Wednesday, April 6, 2016

What does Arbor mean?



What does Arbor mean when shopping for circular saw blades?

ARBOR is the shaft, driven by the saw's motor, which turns the saw blade, aka a mandrel.

ARBOR HOLE or size refers to the center bore or center hole in the blade through which the ARBOR passes through. This must be accurately broached or cuts will waver.

The ARBOR size can be found in the manual that the saw came with.

What does Hook Angle mean?

Have you ever wonder what Hook Angle means?
Hook angle refers to the angle to which the blade enters the material.

Hook Angles
The hook angle is the amount of forward or backward lean each tooth has.  A hook angle can be thought of as the angle at which the tip enters the material.  If the saw tip enters the material at an angle it will be more efficient than if it slaps down flat.  A 20 degree positive hook angle is used on rip blades to pull the wood into the blade. Standard hook angles range from 5 to 15 degrees positive. Steeper angles, from 18 to 22 degrees, are most effective for ripping and cutting softer materials.  Hard materials require a shallow angle such as 6 degrees.  Negative hook angles, usually -5 degrees, are used to prevent self-feeding of materials and give the operator maximum control over the feed of cut. 
Using a saw blade with a positive hook angle to cut metal, such as aluminum trim, can be dangerous because the blade will have a strong tendency to grab the material causing the operator to lose control.  To prevent self-feeding, sliding miter saws and radial-arm saws require a blade with a negative tooth angle.
 In general, a blade with a positive hook angle is a faster-feeding blade and one with a negative hook is less aggressive.  One thing we need to add here is that you ALWAYS want a negative hook for cutting metal and the new SystiMatic Melamine blade is a negative hook - it seems to work better for cutting Melamine.
Tangential Clearance Angle (Side Clearance Angle)
You measure down the side of the tip and the difference it is the difference between front and back.  As you cut material it gets compressed and springs back after the cutting edge passes.  A steep side clearance angle gives plenty of room for the material to expand and prevents heating and burning.  However a very flat side clearance angle gives a smoother cut 
information taken from Saw Tip Angles explained

History of Craftsman circular saw blades

Ever wonder when your favorite bands where created and when they became popular?

Check out this site and you can read it here